冻干制剂 comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2025-10-15. Numbers and descriptions here follow the published literature rather than marketing material.
Stability studies focus on deamidation of asparagine and glutamine residues, oxidation of methionine, and aggregation into higher-order species. The fatty acid side chain adds susceptibility to oxidative change and can promote self-association at high concentration. Lyophilised material is comparatively robust when kept cold and dry, while aqueous solutions require refrigeration and protection from light. Forced degradation experiments under heat, acid, base, and peroxide conditions establish the specificity of each analytical method. Which degradation route dominates under real storage conditions depends on the formulation and stays formulation-specific.
Handling guidance for research quantities calls for single-use aliquots, an inert atmosphere where practical, and avoidance of repeated freeze-thaw cycles that accelerate aggregation. Certificates of analysis typically report purity by peak area, water content, counter-ion identity, and residual solvent levels. In the scientific literature the compound is usually described by its full amino acid sequence, its registry number, or its structural class rather than by any proprietary label. Reporting standards vary between journals, and reviewers increasingly request raw chromatograms alongside tabulated purity figures. Whether current purity thresholds are adequate for every experimental context is debated.
容器与密封系统同样参与稳定性表现。硅油涂层、胶塞材质与顶空氧含量可能改变聚集速率与氧化水平。分析结果因此需要在完整包装形式下评估，而不能仅凭原料药数据推断。法规文件通常要求同时提交批次数据与代表性容器中的稳定性趋势。
关于降解产物的免疫原性风险，文献中仍有讨论空间。体外聚集水平与临床免疫反应之间的定量关系尚未确立。多数公开研究只报告理化指标，缺少长期随访的对应数据。这一问题在生物类似物比对中尤其受到关注。
| Property | Value | Notes |
|---|---|---|
| Typical purity assay | reversed-phase HPLC, 220 nm | Amide-bond detection for the peptide backbone |
| Identity confirmation | electrospray mass spectrometry | Peptide mapping used for sequence coverage |
| Related substances | deamidated and oxidised forms | Truncated sequences also monitored |
| Powder storage | -20 degrees Celsius | Keep sealed, dry, and protected from light |
| Solution storage | 2 to 8 degrees Celsius | Avoid repeated freeze-thaw cycling |
Peptides are sensitive to temperature, light, oxygen, and repeated freeze-thaw cycles. Semaglutide in dry form is generally held at refrigerated temperatures, while reconstituted solutions require a defined short-term storage window. Vials should be kept in secondary packaging to limit photodegradation, and exposure to alkaline conditions is avoided because it accelerates chemical degradation. Adsorption to glass and some plastics can reduce the measured concentration of dilute solutions, so low-binding polypropylene containers are preferred for analytical work. Each transfer step introduces a small risk of contamination, and closed handling practices reduce that risk.
Routine characterisation of the peptide relies on reversed-phase high-performance liquid chromatography, often paired with ultraviolet detection near 214 nanometres. Related substances such as deamidated, oxidised, and truncated sequences elute at characteristic positions and are quantified by area percentage. Electrospray ionisation mass spectrometry confirms the molecular mass and can resolve some closely related variants. Peptide mapping after enzymatic digestion provides sequence-level verification and is useful when a full identity profile is required. Method parameters such as column chemistry, gradient, and mobile-phase pH influence the separation and must be reported alongside results.
Material described as research-grade is not necessarily manufactured to pharmaceutical standards, and purity figures depend on the method used to obtain them. A certificate of analysis states the measured purity, the analytical technique, and the batch identifier, but the underlying data are not always included. Independent testing by a second laboratory is a common way to confirm identity and purity. Uncertainties remain about how storage history affects long-term stability, and about how well results from one laboratory transfer to another. Documentation of handling conditions supports comparison between batches.
Reversed-phase high-performance liquid chromatography is widely used to assess purity and to separate the parent peptide from related substances. Mass spectrometry confirms identity and can resolve modifications that differ by a few daltons. Size-exclusion chromatography detects dimers and higher aggregates, which are relevant to both stability and immunogenicity questions. Peptide mapping with enzymatic digestion locates specific modifications along the sequence. Circular dichroism provides a secondary-structure profile, although it gives limited information about local conformational changes.
Quality control for peptide material focuses on identity, purity, content and the profile of impurities. Common degradants include deamidated and oxidised forms, plus aggregates formed during storage or handling. Forced degradation studies under heat, light, acid and peroxide help define which conditions accelerate change and which analytical methods detect it. Limits for individual impurities are set by pharmacopoeial monographs or manufacturer specifications. How much a given impurity affects biological activity is often uncertain, and conclusions may depend on the assay used.
Quality control for research material typically involves reversed-phase HPLC for purity and identity, mass spectrometry for molecular weight confirmation, and Karl Fischer titration for residual water content. Peptide content is often reported as the mass of actual peptide rather than total powder mass, since counterions and water contribute to the latter. A certificate of analysis should list the method used for each specification. Limits and acceptance criteria vary by supplier and by intended application.
Handling practices center on minimizing contamination and adsorption. Lyophilized peptide tends to accumulate static charge, so weighing is done with antistatic measures and calibrated balances. Reconstitution with appropriate solvent should be gentle, avoiding vigorous vortexing that generates foam and shear. Solutions are typically aliquoted before freezing to reduce repeated temperature cycling. Personal protective equipment and a fume hood are standard for powder handling.
Reconstituted solutions are less stable than the dry powder, and stability depends on concentration, pH, buffer composition, and container material. Low-protein-binding tubes reduce loss of peptide to plastic surfaces. Some researchers add a carrier protein to limit adsorption at low concentrations. The exact shelf life of a given solution is best determined empirically through a stability study rather than assumed from general guidance, because published data cover only a limited set of conditions.
However, it is possible that some isotopes that are now considered stable will be revealed to decay with extremely long half-lives (as happened with bismuth). For each of the 80 stable elements, the number of stable isotopes is given. Only 90 isotopes are stable against any possible decay, and an additional 161 are energetically unstable (see List of nuclides) but have never been observed to decay. Thus, 251 isotopes (nuclides) are stable by definition (including an excited state, tantalum-180m, for which no decay has yet been observed). In April 2019 it was announced that the half-life of xenon-124 had been measured to 1.8 × 1022 years. This is the longest half-life directly measured for any unstable isotope; only the (indirectly measured) half-life of tellurium-128 is longer. Of the chemical elements, only 1 element (tin) has 10 such stable isotopes, 5 have 7 stable isotopes, 7 have 6 stable isotopes, 11 have 5 stable isotopes, 9 have 4 stable isotopes, 5 have 3 stable isotopes, 16 have 2 stable isotopes, and 26 have 1 stable isotope. Additionally, 31 nuclides of the naturally occurring elements have unstable isotopes with a half-life long enough to have survived for the age of the Solar System (108 years or more), and an additional four such nuclides represent three elements (bismuth, thorium, uranium) having no stable isotope. These 35 radioactive naturally occurring nuclides comprise the radioactive primordial nuclides. The total number of primordial nuclides is then 251 (the stable nuclides) plus the 35 radioactive primordial nuclides, for a total of 286.
Relugolix is a selective antagonist of the gonadotropin-releasing hormone receptor (GnRHR), with a half-maximal inhibitory concentration (IC50) of 0.12 nM. A dosage of relugolix of 40 mg once per day has been found to suppress estradiol levels to postmenopausal levels (<20 pg/mL) within 24 hours in premenopausal women. In the control group of women, estradiol levels fluctuated between 50 and 250 pg/mL. Estradiol levels have been found to return to normal concentrations within 4 weeks of discontinuation of relugolix in premenopausal women. The medication additionally suppresses levels of progesterone, luteinizing hormone, and follicle-stimulating hormone in premenopausal women. Relugolix at a dosage of 40 mg or more once per day has been found to reduce testosterone levels to sustained castrate levels (<20 ng/dL) in men. It additionally suppresses luteinizing hormone and follicle-stimulating hormone levels in men. Lower doses of relugolix (<40 mg/day) are under investigation for achieving partial sex hormone suppression in the treatment of endometriosis and uterine fibroids. This is intended to reduce the incidence and severity of menopausal symptoms such as hot flushes and decreased bone mineral density that are secondary to estrogen deficiency.
== History == Because of its central geographic position within the Yugoslav federation, post-war Bosnia was strategically selected as a base for the development of the military defense industry. This contributed to a large concentration of arms and military personnel in Bosnia; a significant factor in the war that followed the break-up of Yugoslavia in the 1990s. However, Bosnia's existence within Yugoslavia, for the large part, was peaceful and prosperous. Being one of the poorer republics in the early 1950s it quickly recovered economically, taking advantage of its extensive natural resources to stimulate industrial development. The Yugoslavian communist doctrine of "brotherhood and unity" particularly suited Bosnia's diverse and multi-ethnic society that, because of such an imposed system of tolerance, thrived culturally and socially. The improvements to cultural tolerance throughout Bosnia and Herzegovina culminated with the selection of Sarajevo to host the 1984 Winter Olympics.
Sources: en.wikipedia.org
PEAKS and NovoHMM had the best sensitivity in both QSTAR and LCQ data as well. However, no evaluated algorithms exceeded a 50% of exact identification for both data sets. Recent progress in mass spectrometers made it possible to generate mass spectra of ultra-high resolution [1]. The improved accuracy, together with the increased amount of mass spectrometry data that are being generated, draws the interests of applying deep learning techniques to de novo peptide sequencing. In 2017 Tran et al. proposed DeepNovo, the first deep learning based de novo sequencing software. The benchmark analysis in the original publication demonstrated that DeepNovo outperformed previous methods, including PEAKS, Novor and PepNovo, by a significant margin. DeepNovo is implemented in python with the Tensorflow framework. To represent a mass spectrum as a fixed-dimensional input to the neural-network, DeepNovo discretized each spectrum into a length 150,000 vector. This unnecessarily large spectrum representation, and the single-thread CPU usage in the original implementation, prevents DeepNovo from performing peptide sequencing in real time. To further improve efficiency of de novo peptide sequencing models, Qiao et al. proposed PointNovo in 2020. PointNovo is a python software implemented with the PyTorch framework and it gets rid of the space consuming spectrum-vector-representation adopted by DeepNovo. Comparing with DeepNovo, PointNovo managed to achieve better accuracy and efficiency at the same time by directly representing a spectrum as a set of m/z and intensity pairs.
Dry ice is the solid form of carbon dioxide (CO2), a molecule consisting of a single carbon atom bonded to two oxygen atoms. Dry ice is colorless, odorless, and non-flammable, and can lower the pH of a solution when dissolved in water, forming carbonic acid (H2CO3). At pressures below 5.13 atm and temperatures below −56.4 °C (216.8 K; −69.5 °F) (the triple point), CO2 changes from a solid to a gas with no intervening liquid form, through a process called sublimation. The opposite process is called deposition, where CO2 changes from the gas to solid phase (dry ice). At atmospheric pressure, sublimation/deposition occurs at 194.7 K (−78.5 °C; −109.2 °F). The density of dry ice increases with decreasing temperature and ranges between about 1.55 and 1.7 g/cm3 (97 and 106 lb/cu ft) below 195 K (−78 °C; −109 °F). The low temperature and direct sublimation to a gas makes dry ice an effective coolant, since it is colder than water ice and leaves no residue as it changes state. Its enthalpy of sublimation is 571 kJ/kg (25.2 kJ/mol, 136.5 calorie/g). Dry ice is non-polar, with a dipole moment of zero, so attractive intermolecular van der Waals forces operate. The composition results in low thermal and electrical conductivity.
This results in white woolly appearance and more pleasant aroma compared with tempeh made with commercial starter containing only Rhizopus oligosporus. Famously these variant tempeh are found in Malang and Purwokerto in the 1960s, because Malang is located in a cool plateau, and tempeh made with Rhizopus oligosporus resulted in less compact and more alcoholic-smelling tempeh, while Rhizopus arrhizus required lower optimum temperature which made it more ideal. However the widespread use of commercial starter resulted in most tempeh in Java only containing Rhizopus oligosporus, with few traditionally made tempeh outside Java still containing Rhizopus arrhizus and Rhizopus delemar.
Sources: en.wikipedia.org
Purity is commonly expressed as the percentage of the main peak relative to all integrated peaks in a reversed-phase chromatogram. Related substances and counter-ions are reported separately. Values obtained with different detectors are not always directly comparable.
Aggregation is driven by hydrophobic contacts, especially those involving the fatty acid side chain, and is accelerated by heat, agitation, and repeated freezing and thawing. Low pH and suitable excipients can reduce the rate. The tendency differs between formulations.
Dry powder has low molecular mobility and tolerates colder storage for longer periods. Water enables hydrolysis and conformational change, so dissolved material is kept refrigerated and used within a shorter window.
冻融过程中冰晶形成与局部浓度升高会促使肽链发生界面吸附和聚集。聚集不仅降低有效含量，还会改变可见异物与不溶性微粒的计数结果。将溶液分装为单次使用的小体积等份可减少循环次数。